EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE
23.1 REPLACEMENT OF THE OIL FILTER
“Oil Filter Removal Video”
Remove as follows:
1. Using a 36-mm socket, unscrew the oil
fi
lter cap (1) and
fi
lter (3), and allow the oil to drain
into the housing. After draining is complete, remove the assembly from the housing (4).
NOTE:
For EVO Bus, when removing the filter, separate the cap from the filter before pulling
out of the module. Remove as two separate components.
NOTE:
Use care to prevent foreign objects from entering the filter housing.
2. Remove the
fi
lter element by pressing and twisting the side and detaching it from the
cap. Discard the
fi
lter element.
3. Remove the oil
fi
lter O-ring and discard. Lightly coat a new O-ring with clean engine
oil and install it on the
fi
lter cap.
4. Check the
fi
lter housing for any debris and remove if necessary.
5. Insert a new
fi
lter element into the oil
fi
lter cap.
6. Insert the
fi
lter element and cap assembly into the housing. Torque the cap to 40-50
N·m (30-37 lb·ft).
All information subject to change without notice.
DDC-SVC-MAN-0081 2010
Copyright © 2010 DETROIT DIESEL CORPORATION
23-3
Summary of Contents for EPA07
Page 1: ......
Page 2: ......
Page 287: ...23 OIL FILTER Section Page 23 1 REPLACEMENT OF THE OIL FILTER 23 3 ...