16.3
INSPECTION OF CYLINDER LINER
4. Inspect the block bore and cylinder liner.
[a] Measure the block bore and the outside diameter of the liner.
Location
DD13
DD15
DD16
A
158.98 to 159 mm
(6.2590 to 6.2598 in.)
166.98 to 167 mm
(6.5740 to 6.5748 in.)
166.98 to 167 mm
(6.5740 to 6.5748 in.)
B
141.97 to 141.95 mm
(5.589 to 5.588 in.)
148.95 to 148.97 mm
(5.864 to 5.865 in.)
148.95 to 148.97 mm
(5.864 to 5.865 in.)
Table 16-1
Acceptable Cylinder Liner Diameters
[b] If the liner does not meet speci
fi
cation, replace with a new part.
5. Inspect the cylinder liner.
[a] Check the two seal ring grooves for burrs or sharp edges.
[b] If any are detected, smooth with a Scotch-Brite® pad.
All information subject to change without notice.
16-6
DDC-SVC-MAN-0081 2010
Copyright © 2010 DETROIT DIESEL CORPORATION
Summary of Contents for EPA07
Page 1: ......
Page 2: ......
Page 287: ...23 OIL FILTER Section Page 23 1 REPLACEMENT OF THE OIL FILTER 23 3 ...