Detroit Diesel EPA07, Workshop Manual, Page: 124 / 442

9.4 INSTALLATION OF THE DD13 TURBOCHARGER
9.4 INSTALLATION OF THE DD13 TURBOCHARGER
Install as follows:
PERSONAL INJURY
To avoid injury when removing or installing a heavy engine
component, ensure the component is properly supported
and securely attached to an adequate lifting device to
prevent the component from falling.
1. Attach a chain hoist and a suitable lifting sling to the turbocharger assembly.
2. Remove any covers that were placed over the openings of the air inlet and exhaust outlet
openings on the engine and turbocharger when the turbocharger was removed.
3. Remove any covers on the oil and coolant inlet lines, oil and coolant outlet lines, and
drain openings on the turbocharger.
4. Place a new gasket, face up, with the tab towards outside on the exhaust manifold
turbocharger fl ange.
5. Place the turbocharger assembly into position on the exhaust manifold fl ange studs.
Tighten the nuts just enough to hold the turbocharger in place.
6. Torque the turbocharger exhaust manifold nuts to 50 N·m (37 lb·ft).
7. Install a new gasket and O-ring between the opening in the bottom side of the turbocharger
center housing and the drain line that runs to the cylinder block. Torque the bolts to
30-38 N·m (22-28 lb·ft).
8. Install the turbocharger oil drain line.
9. Install the turbocharger oil supply line. Torque line to 30 N·m (22 lb·ft).
All information subject to change without notice.
9-10
DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION