Detroit Diesel EPA07, Workshop Manual, Page: 356 / 442

34.2 REMOVAL OF FLYWHEEL HOUSING
34.2 REMOVAL OF FLYWHEEL HOUSING
Remove as follows:
1. If the engine is removed from the vehicle, mount the engine on an overhaul stand.
2. Drain engine oil and remove the oil pan.
3. Remove the doser injector feed line.
4. Remove the Crankshaft Position Sensor (CKP). Refer to section .
5. Remove the fl ywheel. Refer to section 34.4.
6. Remove two bolts securing exhaust pipe bracket to fl ywheel housing.
7.
For the DD15;
remove the clamp from the exhaust pipe and the axial power turbine
and then remove exhaust pipe.
8. Thread eye bolts into the tapped holes in the side of the fl ywheel housing and attach a
suitable lifting sling to the eye bolts.
9. Thread two guide stud tools (J-43431) for the 14 mm bolts, into the cylinder block.
10. Remove the remainder of the bolts that secure the fl ywheel housing to the cylinder block.
BODILY INJURY
To avoid injury from a falling component, ensure a proper
lifting device is used. Never stand beneath a suspended
load.
11. Strike the front face of the housing alternately on each side with a soft hammer to loosen
and work it off the dowel pins.
12. Remove and discard the fl ywheel housing gasket.
13. Remove all sealing material from the fl ywheel housing.
All information subject to change without notice.
34-6
DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION