Dell S4048-ON, Configuration Manual

Page: 59 / 1039

level level
command. In the command, specify the privilege level of the user or terminal line and specify all the keywords in the
command to which you want to allow access.
Allowing Access to Different Modes
This section describes how to allow access to the INTERFACE, LINE, ROUTE-MAP, and ROUTER modes.
Similar to allowing access to CONFIGURATION mode, to allow access to INTERFACE, LINE, ROUTE-MAP, and ROUTER modes, you
must first allow access to the command that enters you into the mode. For example, to allow a user to enter INTERFACE mode, use
the
privilege configure level level interface tengigabitethernet
command.
Next, individually identify the INTERFACE, LINE, ROUTE-MAP or ROUTER commands to which you want to allow access using the
privilege {interface | line | route-map | router} level level
command. In the command, specify the
privilege level of the user or terminal line and specify all the keywords in the command to which you want to allow access.
To remove, move or allow access, use the following commands.
The configuration in the following example creates privilege level 3. This level:
• removes the
resequence
command from EXEC mode by requiring a minimum of privilege level 4
• moves the
capture bgp-pdu max-buffer-size
command from EXEC Privilege to EXEC mode by requiring a minimum
privilege level 3, which is the configured level for VTY 0
• allows access to CONFIGURATION mode with the
banner
command
• allows access to INTERFACE and LINE modes are allowed with no commands
• Remove a command from the list of available commands in EXEC mode.
CONFIGURATION mode
privilege exec level level { command ||...|| command }
• Move a command from EXEC Privilege to EXEC mode.
CONFIGURATION mode
privilege exec level level { command ||...|| command }
• Allow access to CONFIGURATION mode.
CONFIGURATION mode
privilege exec level level configure
• Allow access to INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode. Specify all the keywords in the command.
CONFIGURATION mode
privilege configure level level {interface | line | route-map | router} { command-keyword
||...|| command-keyword }
• Allow access to a CONFIGURATION, INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode command.
CONFIGURATION mode
privilege {configure |interface | line | route-map | router} level level { command ||...||
command }
Example of EXEC Privilege Commands
Dell(conf)#do show run priv
!
privilege exec level 3 capture
privilege exec level 3 configure
privilege exec level 4 resequence
privilege exec level 3 capture bgp-pdu
privilege exec level 3 capture bgp-pdu max-buffer-size
privilege configure level 3 line
privilege configure level 3 interface
Dell(conf)#do telnet 10.11.80.201
[telnet output omitted]
Dell#show priv
Management
59