Dell S4048-ON, Configuration Manual

Page: 39 / 1039

CLI Command Mode Prompt Access Command
EIS Dell(conf-mgmt-eis)# management egress-interface-
selection
FRRP Dell(conf-frrp- ring-id )# protocol frrp
LLDP Dell(conf-lldp)# or Dell(conf-
if— interface -lldp)#
protocol lldp (CONFIGURATION or
INTERFACE Modes)
LLDP MANAGEMENT INTERFACE Dell(conf-lldp-mgmtIf)#
management-interface
(LLDP
Mode)
LINE
Dell(config-line-console)
or
Dell(config-line-vty)
line console
or
line vty
MONITOR SESSION Dell(conf-mon-sess-
sessionID )#
monitor session
OPENFLOW INSTANCE Dell(conf-of-instance- of-id )# openflow of-instance
PORT-CHANNEL FAILOVER-GROUP Dell(conf-po-failover-grp)# port-channel failover-group
PRIORITY GROUP Dell(conf-pg)# priority-group
PROTOCOL GVRP Dell(config-gvrp)# protocol gvrp
QOS POLICY Dell(conf-qos-policy-out-
ets)# qos-policy-output
SUPPORTASSIST Dell(support-assist)# support-assist
VLT DOMAIN Dell(conf-vlt-domain)# vlt domain
VRRP Dell(conf-if- interface-type -
slot/port -vrid- vrrp-group-
id )#
vrrp-group
u-Boot Dell=> Press any key when the following line
appears on the console during a system
boot:
Hit any key to stop
autoboot:
UPLINK STATE GROUP Dell(conf-uplink-state-group-
groupID )#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
The do Command
You can enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION, INTERFACE, SPANNING TREE, and
so on.) without having to return to EXEC mode by preceding the EXEC mode command with the
do
command.
The following example shows the output of the
do
command.
Dell(conf)#do show system brief
Stack MAC : 34:17:eb:f2:c2:c4
Reload-Type : normal-reload [Next boot : normal-reload]
Configuration Fundamentals
39