Dell S4048-ON, Configuration Manual

Page: 44 / 1039

3
Getting Started
This chapter describes how you start configuring your system.
When you power up the chassis, the system performs a power-on self test (POST) and system then loads the Dell Networking
Operating System. Boot messages scroll up the terminal window during this process. No user interaction is required if the boot
process proceeds without interruption.
When the boot process completes, the system status LEDs remain online (green) and the console monitor displays the EXEC mode
prompt.
For details about using the command line interface (CLI), refer to the Accessing the Command Line section in the Configuration
Fundamentals chapter.
Console Access
The device has one RJ-45/RS-232 console port, an out-of-band (OOB) Ethernet port, and a micro USB-B console port.
Serial Console
The RJ-45/RS-232 console port is labeled on the upper right-hand side, as you face the I/O side of the chassis.
Figure 1. RJ-45 Console Port
1. RJ-45 Console Port
Accessing the Console Port
To access the console port, follow these steps:
For the console port pinout, refer to
Accessing the RJ-45 Console Port with a DB-9 Adapter .
1. Install an RJ-45 copper cable into the console port.Use a rollover (crossover) cable to connect the S4810 console port to a
terminal server.
2. Connect the other end of the cable to the DTE terminal server.
3. Terminal settings on the console port cannot be changed in the software and are set as follows:
•
115200 baud rate
• No parity
44
Getting Started