3
Assign a
method-list-name
or the default list to the terminal line.
LINE mode
login authentication {
method-list-name
| default}
To view the configuration, use the
show config
command in LINE mode or the
show running-config
in EXEC Privilege mode.
NOTE:
Dell Networking recommends using the
none
method only as a backup. This method does not authenticate users. The
none
and
enable
methods do not work with secure shell (SSH).
You can create multiple method lists and assign them to different terminal lines.
Enabling AAA Authentication
To enable AAA authentication, use the following command.
•
Enable AAA authentication.
CONFIGURATION mode
aaa authentication enable {
method-list-name
| default}
method1
[
... method4
]
•
default
: uses the listed authentication methods that follow this argument as the default list of methods when a user logs in.
•
method-list-name
: character string used to name the list of enable authentication methods activated when a user logs in.
•
method1
[
... method4
]
: any of the following: RADIUS, TACACS, enable, line, none.
If you do not set the default list, only the local enable is checked. This setting has the same effect as issuing an
aaa authentication
enable default enable
command.
Enabling AAA Authentication — RADIUS
To enable authentication from the RADIUS server, and use TACACS as a backup, use the following commands.
1
Enable RADIUS and set up TACACS as backup.
CONFIGURATION mode
aaa authentication enable default radius tacacs
2
Establish a host address and password.
CONFIGURATION mode
radius-server host x.x.x.x key some-password
3
Establish a host address and password.
CONFIGURATION mode
tacacs-server host x.x.x.x key some-password
Examples of the
enable
commands for RADIUS
To get
enable authentication
from the RADIUS server and use TACACS as a backup, issue the following commands.
The following example shows enabling authentication from the RADIUS server.
Dell(config)# aaa authentication enable default radius tacacs
Radius and TACACS server has to be properly setup for this.
Dell(config)# radius-server host x.x.x.x key <some-password>
Dell(config)# tacacs-server host x.x.x.x key <some-password>
To use local enable authentication on the console, while using remote authentication on VTY lines, run the following commands.
700
Security
Summary of Contents for S3048-ON
