Dell PowerConnect 6024, Command Line Interface Reference Manual

Page: 314 / 504

314
QoS Commands
www
.dell.com | support.dell.com
Example
The following example configures the trust state to CoS. The class is in a policy map called
"policy1".
set
The set policy-map class configuration command sets new values in the IP packet. To remove the
value, use the no form of this command.
Syntax
set { dscp new-dscp | queue queue-id | cos new-cos }
no set
• dscp new-dscp —Enter a new DSCP value for classified traffic. (Range: 0 - 63)
• queue queue-id —Enter explicit queue ID to set the egress queue.
• cos
new-cos
—Enter new user priority for marking in the packet. (Range: 0 - 7)
Default Configuration
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
User Guidelines
NOTE:
Policy-maps that contain set or trust commands, or have ACL classification, cannot be attached
to an egress interface by using the service-policy interface configuration command.
Example
The following example sets a new DSCP value in the packet to 56. The class is in a policy map
called "policy1".
service-policy
The service-policy interface configuration command applies a policy map to the interface input. To
detach the policy map from an interface, use the no form of this command.
Console (config)# policy-map policy1
Console (config-pmap)# class class1
Console (config-pmap-c)# trust cos
Console (config)# policy-map policy1
Console (config-pmap)# set dscp 56