Dell PowerConnect 35 SERIES, User Manual

Page: 321 / 474

Configuring Switch Information
321
The following is an example of the CLI commands:
Configuring GARP
Generic Attribute Registration Protocol (GARP) is a general-purpose protocol that registers any network
connectivity or membership-style information. GARP defines a set of devices interested in a given
network attribute, such as VLAN or multicast address.
When configuring GARP, ensure the following:
• The leave time must be greater than or equal to three times the join time.
• The leave-all time must be greater than the leave time.
• Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set
differently on the Layer 2-connected devices, GARP application does not operate successfully.
To open the GARP page, click Switch
→
GARP in the tree view.
This section contians the following topics:
• "Defining GARP Timers" on page 322
console (config)# bridge aging-time 250
console (config)# end
console# show bridge address-table
Aging time is 250 sec
vlan mac address port type
---- ----------- ---- ----
1 00:60:70:4C:73:FF 1/e8 dynamic
1 00:60:70:8C:73:FF 1/e8 dynamic
200 00:10:0D:48:37:FF 1/e8 static