To replace the computer cover, perform the following steps:
1. Check all cable connections, especially those that might have come loose during your work. Fold cables out of the way so that they do not
catch on the computer cover. Make sure cables are not routed over the drive cage
—
they will prevent the cover from closing properly.
2. Check to see that no tools or extra parts (including screws) are left inside the computer's chassis.
3. If your computer has a mini tower chassis, skip to
step 4
. If your computer has a small-form-factor or low-profile chassis, replace the
computer cover as follows:
a. Face the front of the computer and hold the cover at a slight angle as shown in
Figure 4
and
Figure 5
.
b. Align the bottom of the cover with the bottom of the chassis, and insert the hooks on the cover into the recessed slots on the computer
chassis so that the tabs catch the hooks inside the slots.
c. Pivot the cover down toward the back of the chassis and into position. Make sure that the securing buttons click into place.
Figure 4. Replacing the Small-Form-Factor Computer Cover
Figure 5. Replacing the Low-Profile Computer Cover
1
Release button
Summary of Contents for OptiPlex GX100
Page 64: ...Back to Contents Page ...
