Dell C600 - Latitude Intel P-4 1.4GHz, User Manual

Page: 78 / 188

The battery’s self-test capability alerts you to battery conditions such as low charge.
The battery has a life span of around 400 discharge/charge cycles, provided it is charged at normal
room temperature.
Battery Usage
The battery is partially charged when you receive it. Dell recommends that you charge your battery to full
capacity before using it to power the computer. For information on conserving battery power, see "
Power
Management Modes ."
When you activate suspend mode (known as standby in the Microsoft® Windows® 98 and Windows 2000
operating systems), the computer can run on a fully-charged battery for approximately one week.
If you are going to store the computer, disconnect all peripheral devices and turn off the computer. Remove
the battery when you store your computer for an extended period of time. A battery will drain when not in use
during prolonged storage. After a long storage period, recharge the battery fully before you attempt to run
your computer from the battery.
Removing a Battery
CAUTION: Using the wrong battery type may present a risk of fire or explosion.
Replace the battery only with the same or equivalent type purchased from Dell.
You can use your computer's battery in any Latitude C-Family computer
except
for
the Latitude CS or CS
x
computers. Do not attempt to use the battery in CS or CS
x
computers, and do not use a battery from those computers in your computer.
NOTICE: To avoid data loss, do not replace a battery while the computer is turned on
unless the computer is connected to an electrical outlet or a second battery is
installed.
NOTICE: Only use lithium ion batteries in your computer. The computer does not
support nickel-metal hydride (NiMH) batteries. If you install a NiMH battery, the battery
status lights blink alternately green and amber.
NOTICE: If you choose to replace the battery with the computer in standby mode, you
have up to 4 minutes to complete the battery replacement. After 4 minutes, the
computer shuts down and you will lose any unsaved data.
1.
Ensure that the computer is turned off, suspended in a power management mode, or connected to an
electrical outlet.
2.
If the computer is docked, undock it.
3.
Close the display and turn the computer over.
4. Slide and hold the battery bay (or module bay) latch release on the bottom of the computer, and then
remove the battery from the bay.
Figure 1. Removing a Battery