Figure 52. Installing the heat sink
Next steps
1
Install the heat sink.
2
Install the air shroud.
3
Follow the procedures in
After working inside your system
Drive backplane
Removing the drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before removing the
backplane.
CAUTION:
Note the number of each drive and temporarily label them before removal so that you can replace them in the same
drive slots.
1
Follow the safety guidelines listed in
2
Follow the procedures in
Before working inside your system
3
.
4
Disconnect the following cables from the backplane:
a
Backplane signal cable
b
Backplane power cable
c
PERC cable
NOTE:
Observe the routing of the cable as you remove it from the system.
Steps
1
Press the blue release tabs to disengage the drive backplane from the hooks on the system.
2
Lift the drive backplane out of the system.
Disassembly and reassembly
83
