Steps
1
Connect the PERC cable to the PERC card.
2
Flip and insert the PERC card in the PERC card slot.
3
Press the tab on the blue release latch to disengage it from the slot on the system.
4
Rotate the blue release latch until it locks with the PERC card.
5
Secure the blue release latch with a screw.
Figure 43. Installing the PERC card
Next steps
1
Install the expansion card riser.
2
Follow the procedures in
After working inside your system
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.
•
Follow the safety guidelines listed in
•
Follow the procedures in
Before working inside your system
Steps
1
Locate the battery socket. For more information, see the
section.
2
Tilt the battery partially to release it from the battery holder.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
3
Pull the battery from the battery holder.
76
Disassembly and reassembly
