Steps
1
Route the control panel cable through the side wall and the guide slots in the system and connect it to the system board.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2
Align and insert the left control panel assembly in the slot on the system.
3
Using the appropriate screwdriver, tighten the screws that secure the left control panel.
Figure 66. Installing the left control panel
Next step
1
Follow the procedures in
After working inside your system
Removing the right control panel
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedures in
Before working inside your system
Steps
1
Disconnect the control panel cable from the connector on the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
2
Using the appropriate screwdriver, remove the screws that secure the right control panel.
3
Hold the right control panel assembly and remove it from the system.
96
Disassembly and reassembly
