Jumper
Setting
Description
NVRAM_CLR
The BIOS configuration settings are retained at system boot.
The BIOS configuration settings are cleared at system boot.
Disabling forgotten password
The software security features of the system include a system password and a setup password. The password jumper enables or disables
password features and clears any password(s) currently in use.
Prerequisite
NOTE:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell EMC is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
Steps
1
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2
Remove the .
3
Move the jumper on the system board jumper from pins 2 and 4 to pins 4 and 6.
4
Install the .
The existing passwords are not disabled (erased) until the system boots with the jumper on pins 4 and 6. However, before you assign a
new system and/or setup password, you must move the jumper back to pins 2 and 4.
NOTE:
If you assign a new system and/or setup password with the jumper on pins 4 and 6, the system disables the new
password(s) the next time it boots.
5
Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.
6
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
7
Remove the .
8
Move the jumper on the system board jumper from pins 4 and 6 to pins 2 and 4.
9
Install the .
10 Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.
11 Assign a new system and/or setup password.
Jumpers and connectors
53
