For more information, see the
Integrated Dell Remote Access Control User's Guide
located at
Device Settings
Use
Device Settings
to configure device parameters.
Dell Lifecycle Controller
Dell Lifecycle Controller provides advanced embedded systems management capabilities including system deployment, configuration,
update, maintenance, and diagnosis. Lifecycle Controller is delivered as part of the iDRAC solution.
Embedded systems management
The Dell Lifecycle Controller provides advanced embedded systems management throughout the lifecycle of the system. The Dell Lifecycle
Controller can be started during the boot sequence and can function independently of the operating system.
NOTE:
Certain platform configurations may not support the full set of features provided by the Dell Lifecycle Controller.
For more information about setting up the Dell Lifecycle Controller, configuring hardware and firmware, deploying the operating system, and
platform support see the documentation available at the
Boot Manager
Use the
Boot Manager
screen to select boot options and diagnostic utilities.
Viewing Boot Manager
To enter Boot Manager:
1
Turn on or restart your system.
2
Press F11 when you see the following message:
F11 = Boot Manager
If your operating system begins to load before you press F11, allow the system to complete the booting, and then restart your system
and try again.
Boot Manager main menu
Menu item
Description
Continue Normal
Boot
The system attempts to boot to devices starting with the first item in the boot order. If the boot attempt fails, the
system continues with the next item in the boot order until the boot is successful or no more boot options are
found.
One-shot Boot
Menu
Enables you to access boot menu, where you can select a one-time boot device to boot from.
Launch System
Setup
Enables you to access System Setup.
Pre-operating system management applications
49
