Datex-Ohmeda Engstrom Carestation, Technical Reference Manual

Page: 182 / 225

Engström Carestation
8-20 08/07 1505-1018-000
8.6.8 Logging checkout
results
The ventilator does not have to be in the Service Mode to log the checkout
results.
• Power on the system and wait for the Patient Setup menu to display.
Note: For systems with 4.2X software, wait for the Select Patient menu to
display, then select
Patient Setup menu .
• Connect a PC to the system and start the PC Application software (Revision
1.58 or higher).
1. Access the Log Calibration result to file area of the PC Service Application
and select Find Log File .
2. Select the desired folder from your PC hard drive to store Log Files.
• Rename the file and select OPEN .
Suggested file naming convention: Serial date+"ck.log"
• If a Log File does not exist a message window displays. "Select Yes to
create a Log File."
3. Verify the file address location displayed in the
Log Calibration results to
file area
and select Start Logging .
• The Status Log window displays and indicates that the log has been
initialized.
4. From the EC Ventilator, access the Patient Setup menu and select
Checkout .
• Follow the screen instructions and select Start Checkout .
Information from the ventilator will begin loading into the log after a few
seconds.
5. From the PC, select Stop Log from the Status Log window after checks are
complete.
6. Select Save Log from Status Log window
As each system checkout occurs the Status Log will display Pass or Fail. If a
checkout fails the log will record and display information about the exact
parameter that failed. This information is essential in determining the cause
for checkout failure(s).
Always include the Log file when iTrak quality
reports are submitted.