Datcon PQRM5100 11 U I Series, Instruction Manual

Page: 22 / 80

PQRM5100 11 Ux Ix xx xx (PS)
22
20200205-V1
5.10. Connecting the power supply
The following figure shows the wiring plan, connecting the
PQRM5100 11 Ux Ix xx xx to the power supply
Wiring plan, connecting
the power supply
In case of DC supply the
polarity is indifferent
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to
the wiring plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
Checking the
connections
Check if the cables are connected properly (have you
connected all the cables, have you connected to the right
place, do not the cable-ends touch each other).
Put the instrument
under supply voltage
After you have completed all the connections, put the
instrument under supply voltage. If the connections are
correct the green indicator gives light and you can detect an
output signal according to the measured value by the
instrument.