Datcon PQRM5100 11 U I Series, Instruction Manual, Page: 21 / 80

PQRM5100 11 Ux Ix xx xx (PS)
20200205-V1
21
5.9. Connecting the analog output to signal processing
unit
The following figure shows the wiring plan, connecting the
devices with Analog output option to processing unit
Wiring plan, connecting
the analog output to the
signal processing unit
Be careful the polarity of
the cables!
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to
the wiring plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
Checking the
connections
Check if the cables are connected properly (have you
connected all the cables, have you connected to the right
place, do not the cable-ends touch each other).