Datalogic Magellan 8500Xt, Product Reference Manual, Page: 167 / 480

Product Reference Guide
7-29
Good Read When to Indicate
This feature specifies when the scanner will provide indication (beep and/
or flash its green LED) upon successfully reading a barcode.
• Good Read = Indicate after decode
NOTE
For scanner models having intelligent integrated EAS, label transmission
(and hence the good read beep) is completed after the EAS logic executes.
• Good Read = Indicate after transmit
• Good Read = Indicate after CTS goes inactive, then active
NOTE
The “Indicate after CTS goes inactive...” mode applies to RS-232 STD and
RS-232 WN interfaces only. If set to this mode in other interfaces, “Indicate
after decode” mode will be implemented.
• Good Read = Indicate after each output structure proofed
NOTE
When beeping after each output structure decoded, if there are multiple out-
put structures, there is a delay after the beep has finished. This delay is
equal to the
Good Read Beep Length
.
To set the Good Read When to Indicate feature:
1. Scan the SWITCH barcode.
2. Scan the desired mode barcode from the following pages. You’ll
need to cover any unused barcodes on facing pages to ensure that
the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
barcode.