Datakom D-500 MK2, User Manual

Page: 131 / 197

D-500 MK2 User Manual Firmware V-6.3
- 131 -
Parameter Definition Factory Set Description
Mail Account Name d500_a
This is the account name appearing in the
“
from
” tab
of the e-mail recipient. (ex: D500@gmail.com)
Mail Account
Password
d500_1234 This is the e-mail password of above e-mail account.
Mail Server Address smtp.mail.yahoo.com
This is the Outgoing Mail Server Address of the above
e-mail account (ex: smtp.gmail.com)
E-mail Address-1
E-mail Address-2
E-mail Address-3 -
-
- These are e-mail recipient addresses where the unit is
intended to send e-mail messages. Up to 3 e-mails can
be sent at once.
Parameter Definition Unit Min Max
Factory
Set
Description
Web Programming
Enable
- 0 1 0
0: Web programming disabled
1: Web programming enabled
Web Control Enable - 0 1 0
0: Web control disabled
1: Web control enabled
Web Refresh Rate sec 0 240 5
The unit will refresh the web page with
this interval.
Ping Period min 0 240 0
The unit will check the availability of the
internet connection with this interval.
Rainbow Refresh Rate sec 0 65535 5
The unit will update the distant
monitoring terminal with this rate.
Rainbow Address-1 Port - 0 65535 0
This is the port number of the first
monitoring terminal address.
Rainbow Address-2 Port - 0 65535 0
This is the port number of the second
monitoring terminal address.
Web Server Port - 0 65535 80
This is the port number of the internal
web server. The unit will answer queries
to this port only.
Modbus TCP/ Port - 0 65535 502
This is the port number of the internal
Modbus TCP/IP terminal. The unit will
answer Modbus requests to this port
only.
SMTP Port - 0 65535 587
This is the port number used for e-mail
sending.
Ethernet Enable - 0 1 1
0: ethernet port disabled
1: ethernet port enabled
E-mail on IP Change - 0 1 0
This parameter controls e-mail sending
when IP address of GPRS or ethernet
connection is changed. No warnings
generated.
0: no e-mail on IP change
1: e-mail sent on IP change
17.14. ETHERNET PARAMETERS (continued)
Below ETHERNET related parameters are found in the
Controller Configuration group.