DataCard ImageCard IV, User Manual, Page: 53 / 204

Loading supplies
4-7
User’s Guide for the ImageCard® IV Printer
Load cleaning tape in the cartridge
1 Place the cleaning tape cartridge upside down on a level surface, such as a table,
with the glide roller toward you.
2 Pull up firmly on the full take-up roll to remove it.
Do not re-use cleaning tape. The cleaning mechanism does not operate
properly if you attempt to re-use cleaning tape.
3 Remove the end of the cleaning tape from the empty supply spool. Dispose of
used cleaning tape according to your policy.
4 Remove the empty supply spool.
5 Unwrap the new cleaning tape.
6 Remove the label from the new cleaning tape roll and discard it. Unroll a few
inches of tape.
7 Press the end of the new cleaning tape onto the empty take-up spool (step 1 in
Figure 4-6 ). Make sure the edges of the tape align with edges of the spool so the
tape moves evenly.
8 Hold both rolls near the glide roller.
9 Place the full supply roll on the supply spool holder so the tape will unroll
clockwise (step 2 in
Figure 4-6 ). Make sure the ribs inside the spool align with the
grooves of the spool holder.
10 Press on the spool and turn slightly (if needed) until the spool fully covers the
spool holder ribs.
11 Move the take-up spool back so it aligns with the take-up spool holder (step 3 in
Figure 4-6 ).
E