DM DOC 040 Rev 1.0
Battery Operation and Maintenance
D-MAS HyperSat is powered by Battery Blades or by a 19v power supply. Before using D-MAS
the Battery Blades need to be fully charged.
To charge a battery ensure that AC power is attached to the AC Adapter and verify that the battery
is charging
with the battery charge LED.
The battery requires approximately 2 hours for charging. When the battery charging LED
indicators turn green, additional trickle charging may occur to complete charging.
CAUTIONS:
■
AT LOW BATTERY CHANGE TO A FULLY CHARGED BATTERY TO PREVENT LOSS
OF POWER.
During battery operation of D-MAS, please note that the following operating conditions affect the
estimated run-time of the included battery:
■
ILLUMINATION OF THE BACKLIT LCD SCREEN. TO CONSERVE BATTERY POWER,
KEEP THE BACKLIT LCD SCREEN AT MINIMUM ILLUMINATION.
■
VOLUME OF THE ALARM TONES. TO CONSERVE BATTERY POWER, KEEP THE
FREQUENCY OF THE AUDIBLE ALARMS TO A MINIMUM AND AT MINIMUM
VOLUME.
Memory effects of the battery pack may shorten run-time. When battery run time is significantly
reduced, it is advisable to completely discharge and fully recharge the battery pack.
CAUTION:
IF D-MAS HAS NOT BEEN USED OR CHARGED WITHIN SEVEN (7) DAYS
OR MORE, THEN RECHARGE THE BATTERY BLADES PRIOR TO USE.
FOLLOW LOCAL GOVERNING GUIDELINES FOR PROPER DISPOSAL OF
BATTERIES. DO NOT INCINERATE.
WARNING:
FIRE HAZARD: TO PROTECT AGAINST FIRE HAZARD, REPLACE ONLY
WITH CORRECT BATTERY OF THE SAME TYPE, CURRENT RATING,
AND VOLTAGE RATING.
DO NOT OPEN BATTERY BLADE. NO USER SERVICEABLE PARTS INSIDE.
REFER TO QUALIFIED PERSONEL.
© 2013 DanMedical Ltd
83
