Danfoss VLT Integrated Servo Drive ISD 510 System, Operating Instructions Manual

Page: 21 / 102

Number Description/connector name Name on
corresponding
connector Number Description/connector name Name on
corresponding
connector
1 Local control panel (LCP) – 18 Hybrid cable line 2 –
2 Front cover – 19 Decoupling plate –
3 STO 1 IN: STO
(Used for STO input voltage 1) +STO– 20 Shielded cable grounding
clamp and strain relief –
4 STO 1 IN: 24 V
(Used for bridging when the STO function
is not required, see
chapter 3.3.1.1 STO
Connectors )
+24V– 21 24/48 V IN
(Auxiliary input terminal) +AUX–
5 LEDs for status of auxiliary output and
STO – 22 Relay 1 Relay 1
6 Decoupling clamp for STO cable – 23 Relay 2 Relay 2
7 ISD Line 2: STO 2
(STO output to hybrid cable line 2) +STO– 24 Brake R– (81), R+ (82)
8 ISD Line 2: NET 2 X4
(Ethernet output to hybrid cable line 2) RJ45 connector
(without label) 25 Mains
(Input terminal) L1 (91), L2 (92), L3
(93)
9 ISD Line 2: AUX 2
(Auxiliary output to hybrid cable line 2) +AUX– 26 Decoupling fixture for Ethernet
inputs –
10 ISD Line 2: UDC 2
(UDC output to hybrid cable line 2) +UDC– 27 Decoupling clamp for encoder
cable –
11 ISD Line 1: STO 1
(STO output to hybrid cable line 1) +STO– 28 X1
(Ethernet input line 1) RJ45 connector
(not included)
12 ISD Line 1: NET 1 X3
(Ethernet output to hybrid cable line 1) RJ45 connector
(without label) 29 X2
(Ethernet input line 2) RJ45 connector
(not included)
13 ISD Line 1: AUX 1
(Auxiliary output to hybrid cable line 1) +AUX– 30 GND, 24 V, GX, /RS422 TXD,
RS422 TXD, /RS422 RXD, RS422
RXD
(Encoder terminal) Not labeled
14 ISD Line 1: UDC 1
(UDC output to hybrid cable line 1) +UDC– 31 STO 2 IN: STO
(Used for STO input voltage 2) +STO–
15 Grounding PE clamp for hybrid cable line
2 – 32 STO 2 IN: 24 V
(Used for bridging when the
STO function is not required,
see
chapter 3.3.1.1 STO
Connectors )
+24V–
16 Grounding PE clamp for hybrid cable line
1 – 33 Cover –
17 Hybrid cable line 1 – – – –
Table 3.6 Legend to Illustration 3.8
3.3.1 Connections on the SAB
All required connectors are included with the SAB.
All cabling must comply with national and local regulations
on cable cross-sections and ambient temperature. Use
shielded/armored cables to comply with EMC emission
specifications.
System Description Operating Instructions
MG75K102 Danfoss A/S © 12/2015 All rights reserved. 19
3 3