11.1.4 Permitted Forces
20
Fa
Fr
130BE662.10
Illustration 11.6 Permitted Forces
shows the maximum permitted forces on
the motor shaft.
The maximum axial and radial load while assembling the
motor and for any mechanical device connected to the
shaft, must not exceed the values shown in
. The
shaft must be loaded slowly and in a constant manner:
Avoid pulsating loads.
See the
VLT
®
Integrated Servo Drive ISD
®
510 System Design
Guide
for bearing load curves.
NOTICE
The bearing could be permanently damaged if the
maximum permitted forces are exceeded.
Motor size
Radial Force (Fr) in N
Axial Force (Fa) in N
Size 1
450
1050
Size 2
900
1700
Table 11.4 Permitted Forces
11.1.5 General Specifications and
Environmental Conditions
Vibration test
Random vibration: 7.54 g (2h/axis according
to EN 60068-2-64)
Sinusoidal vibration: 0.7 g (2h/axis
according to EN 60068-2-6)
Maximum relative
humidity
Storage/transport: 5–93% (non-condensing)
Stationary use: 15–85% (non-condensing)
Ambient
temperature range
5–40
°
C above derating, maximum 55
°
C
(24-hour average maximum 35
°
C)
Transport: -25 to +70
°
C
Storage: -25 to +55
°
C
Installation
elevation
Maximum 1000 m above sea level
EMC standard for
emission and
immunity
EN 61800-3
Table 11.5 General Specifications and Environmental Conditions
for Servo Drive
Protection ratings
130BE724.10
IM B5
IM V1
IM V3
Illustration 11.7 Mounting Positions
Mounting position of
servo drive
(according to DIN 42 950)
IP rating
(according to
EN 60529)
Housing
All positions
IP67
Shaft without shaft
seal
IM B5 & IM V1
IP54
IM V3
IP50
Shaft with shaft
seal
IM B5 & IM V1
IP65
IM V3
IP60
Table 11.6 Protection Ratings
Specifications
VLT
®
Integrated Servo Drive ISD
®
510 System
88
Danfoss A/S © 12/2015 All rights reserved.
MG75K102
11
11
