![Danfoss VLT Decentral FCD 300 Manual Download Page 98](http://html1.mh-extra.com/html/danfoss/vlt-decentral-fcd-300/vlt-decentral-fcd-300_manual_507844098.webp)
Decentral Solutions
Group no.
Parameter group
0
Operation & Display
1
Load & Motor
2
References & Limits
3
Inputs & Outputs
4
Special functions
5
Serial communication
6
Technical functions
When the required parameter group has been
selected, each parameter can be chosen by
means of the [+ / -] keys:
FREQUENCY
001 LANGUAGE
ENGLISH
50.0 Hz
The 3rd line of the display shows the parameter
number and name, while the status/value of the
selected parameter is shown in line 4.
Changing data
Regardless of whether a parameter has been
selected under the Quick menu or the Menu mode,
the procedure for changing data will be the same.
Pressing the [CHANGE DATA] key gives access
to changing the selected parameter, following
which the underlining in line 4 will flash on the
display. The procedure for changing data depends
on whether the selected parameter represents a
numerical data value or a text value.
Changing a data value
If the selected parameter is a text value, the text value
is changed by means of the [+ / -] keys.
50.0 Hz
FREQUENCY
001 LANGUAGE
ENGLISH
The bottom display line will show the value that will be
entered (saved) when acknowledgment is given [OK].
Change of numeric data value
If the selected parameter is represented by a numerical
data value, a digit is first chosen using the [< >] keys.
50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
0
9
.0 HZ
The selected digit can then be changed infinitely
variably using the [+ / -] keys:
50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
1
0.0 HZ
The chosen digit is indicated by the digit flashing. The
bottom display line shows the data value that will be
entered (saved) when signing off with [OK].
■
Manual initialization
NOTE
Manual initialization is not possible on
the LCP 2 175N0131 control unit. It is,
however, possible to perform an initialization
via par. 620
Operation mode
:
The following parameters are not changed when
initializing via par. 620
Operation mode
.
-
par. 500
Address
-
par. 501
Baud rate
-
par. 600
Operating hours
-
par. 601
Hours run
-
par. 602
kWh counter
-
par. 603
Number of power-ups
-
par. 604
Number of overheatings
-
par. 605
Number of overheatings
-
par. 615-617
Fault log
-
par. 678
Configure Control Card
MG.90.F2.22 - VLT is a registered Danfoss trademark
98