Danfoss VLT AutomationDrive FC 300 Series, Programming Manual, Page: 164 / 211

1-10 Motor Construction AC motor PM Non salient Motor
1-01 Motor Control Principle
U/f mode VVC plus
Flux
sensorless
Flux w/
motor
feedback
U/f mode
Flux
sensorless
Flux w/
motor
feedback
1-80 Function at Stop + + + + + + +
1-81 Min Speed for Function at
Stop [RPM]
(Par. 002 = rpm)
+ + + + + + +
1-82 Min Speed for Function at
Stop [Hz]
(Par. 002 = Hz)
+ + + + + + +
1-83 Precise Stop Function + + + + + + +
1-84 Precise Stop Counter Value + + + + + + +
1-85 Precise Stop Speed Compen-
sation Delay
+ + + + + + +
1-90 Motor Thermal Protection + + + +
1-91 Motor External Fan + + + +
1-93 Thermistor Resource + + + +
1-95 KTY Sensor Type + + + +
1-96 KTY Thermistor Resource + + + +
1-97 KTY Threshold level + + + +
1-98 ATEX ETR interpol. points
freq.
+ + + +
1-99 ATEX ETR interpol points
current
+ + + +
2-00 DC Hold Current + + + +
2-01 DC Brake Current + + + +
2-02 DC Braking Time + + + +
2-03 DC Brake Cut In Speed
[RPM]
+ + + +
2-04 DC Brake Cut In Speed [Hz] + + + +
2-05 Maximum Reference + + + +
2-10 Brake Function +
see 9)
+ + +
2-11 Brake Resistor (ohm) + + + +
2-12 Brake Power Limit (kW) + + + +
2-13 Brake Power Monitoring + + + +
2-15 Brake Check +
see 9)
+ + +
2-16 AC brake Max. Current - + + +
2-17 Over-voltage Control + + + +
2-18 Brake Check Condition + + + +
2-19 Over-voltage Gain + + + -
2-20 Release Brake Current + + + +
2-21 Activate Brake Speed [RPM] + + + +
2-22 Activate Brake Speed [Hz] + + + +
2-23 Activate Brake Delay + + + +
2-24 Stop Delay - - - +
2-25 Brake Release Time - - - +
2-26 Torque Ref - - - +
2-27 Torque Ramp Time - - - +
2-28 Gain Boost Factor - - - +
Table 4.5
9) Not AC brake
Parameter Lists
VLT
®
AutomationDrive Programmming Guide
MG33ME02 - VLT
®
is a registered Danfoss trademark 163
4 4