![background image](http://html1.mh-extra.com/html/daedong/dsc48/dsc48_workshop-manual_3148688123.webp)
Apr. 2007
2
-47
DSC48
417W291A
417W290A
417W289A
►
CAMSHAFT OIL CLEARANCE
1. Measure the I.D. of the camshaft bore on the crank-
case with an inside micrometer.
2. Measure the O.D. of the camshaft journal with an out-
side micrometer.
3. If the clearance exceeds the allowable limit, replace the
shaft.
►
CAMSHAFT ALIGNMENT
1. Support the camshaft's both end journals with V blocks
on a
fl
at table. And set a dial indicator with its tip on the
intermediate journal.
2. Rotate the camshaft on the V block and get the eccen-
tricity (half of the measurement).
3. If the eccentricity exceeds the allowable limit, replace
the camshaft.
►
CAM HEIGHT
1. Measure the height of the camshaft lobes at their larg-
est O.D. with an outside micrometer.
2. If the measurement is less than the allowable limit, re-
place the camshaft.
Factory spec.
Allowable limit
Oil clearance
0.050 ~ 0.091 mm
0.002 ~ 0.004 in.
0.15 mm
0.006 in.
Journal O.D.
39.934 ~ 39.950 mm
1.572 ~ 1.573 in.
-
Bore I.D.
40.000 ~ 40.025 mm
1.575 ~ 1.576 in.
-
Allowable limit
0.05 mm
0.002 in.
Factory spec.
Allowable limit
(IN.)
33.59 mm
1.322 in.
33.54 mm
1.320 in.
(EX.)
33.69 mm
1.326 in.
33.64 mm
1.324 in.
Summary of Contents for DSC48
