
Apr. 2007
1
-19
DSC48
1.9.3 INITIAL 50 HOURS
A. CHANGING ENGINE OIL
1. Stop the engine. Then, drain the engine oil before it
gets cool. Drain the oil completely and then add the
speci
fi
ed amount of oil through the inlet.
417W144A
(1) Drain
plug
417W145A
(1) Oil
Inlet
(2) Oil
gauge
(A) Oil level is acceptable within this range
• Be sure to stop the engine before changing engine oil.
CAUTION
2. Replace the oil
fi
lter when changing the engine oil.
3. After changing the engine oil, start the engine, run it for
approx. 2 minutes and stop it. Then, check the oil level
again.
B. CHANGING TRANSMISSION FLUID
1. Remove the drain plug and drain the
fl
uid completely.
2. Remove the HST
fi
lter and hydraulic
fi
lter.
3. Install new
fi
lters. Thinly apply oil to the
fi
lters' gaskets.
4. Add oil to the speci
fi
ed level through the oil inlet and
check the
fl
uid level with the level check bolt.
417W146A
(1) Oil
inlet
(2) Level check bolt
(3) Drain
plug
•
Stop the engine before checking the transmission
fl
uid
level or changing the
fl
uid.
CAUTION
Temperature
Oil type
Capacity
15ºC or higher
Diesel engine oil 30 or
15W-40
8.0
ℓ
Below 15ºC
Diesel engine oil 15W-40
Type
Capacity
Daedong TF65
7.1
ℓ
Summary of Contents for DSC48
