D-Link TM DES-6500, Command Line Interface Reference Manual

Page: 142 / 267

Example usage:
To display the 802.1x authtication states (stacking disabled):
DES-6500:4#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
802.1X : Enabled
Authentication Mode : Port_based
Authentication Protocol : Radius_Eap
SuppTimeout : 30 sec
ReAuthenticate : Disabled
Port number : 1:2
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60 sec
TxPeriod : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
show 802.1x auth_state
Purpose Used to display the current authentication state of the 802.1x server on
the switch.
Syntax show 802.1x auth_state {ports [<portlist>|all]}
Description The show 802.1x auth_state command is used to display the current
authentication state of the 802.1x Port-based Network Access Control
server application on the switch.
Parameters
ports <portlist>
−
Specifies a range of ports. The port list is specified by
listing the lowest switch number and the beginning port number on that
switch, separated by a colon. Then highest switch number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated by
a dash. For example, 3 would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port 4
−
in numerical order.
all
−
Specifies all of the ports on the switch.
The following details what is displayed:
Port number
−
Shows the physical port number on the switch.
Auth PAE State: Initalize|Disconnected|Connecting|
Authenticating|Authenticated|Held |ForceAuth|ForceUnauth
−
Shows
the current state of the Authenticator PAE.