D-Link TM DES-6500, Command Line Interface Reference Manual

Page: 91 / 267

DES-6500
show multicast_fdb
Purpose Used to display the contents of the switch’s multicast forwarding
database.
Syntax
show mulitcast_fdb [vlan <vlan_name 32>|mac_address
<macaddr>]
Description This command is used to display the current contents of the switch’s
multicast MAC address forwarding database.
Parameters
<vlan_name 32>
−
The name of the VLAN on which the MAC address
resides.
<macaddr>
−
The MAC address that will be added to the forwarding
table.
Restrictions None.
Example usage:
To display multicast MAC address table:
DES-6500:4#show multicast_fdb
Command: show multicast_fdb
VLAN Name : default
MAC Address : 01-00-5E-00-00-00
Egress Ports : 1:1-1:5,1:26,2:26
Mode : Static
Total Entries : 1
show fdb
Purpose Used to display the current unicast MAC address forwarding database.
Syntax show fdb {port <port>|vlan <vlan_name 32>|mac_address
<macaddr>|static|aging_time}
Description This command will display the current contents of the switch’s
forwarding database.
Parameters
<port>
−
The port number corresponding to the MAC destination
address. The switch will always forward traffic to the specified device
through this port. The port list is specified by listing the lowest slot
number and the beginning port number on that slot, separated by a
colon. Then the highest slot number, and the highest port number of
the range (also separated by a colon) are specified. The beginning and
end of the port list range are seperated by a dash. For example, 1:3
specifies slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-
2:4 specifies all of the ports between slot 1, port 3 and slot 2, port 4
−
in
numerical order.
<vlan_name 32>
−
The name of the VLAN on which the MAC address
resides.