D-Link TM DES-6500, Command Line Interface Reference Manual, Page: 37 / 267

DES-6500
6
P
ORT
S
ECURITY
C
OMMANDS
The switch port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config port_security ports [<portlist>| all ] {admin_state [enabled| disabled] |max_learning_addr
<max_lock_no 0-64> | lock_address_mode
[DeleteOnTimeout|DeleteOnReset]}
show port_security {ports <portlist>}
Each command is listed, in detail, in the following sections.
config port_security ports
Purpose
Used to configure port security settings.
Syntax config port_security [<portlist>| all ] {admin_state [enabled| disabled]
|max_learning_addr <max_lock_no 0-64> | lock_address_mode
[DeleteOnTimeout|DeleteOnReset]}
Description This command allows for the configuration of the port security feature. Only the
ports listed in the <portlist> are effected.
Parameters portlist
−
specifies a range of ports to be configured. The port list is specified
by listing the lowest slot number and the beginning port number on that slot,
separated by a colon. Then the highest slot number, and the highest port
number of the range (also separated by a colon) are specified. The beginning
and end of the port list range are seperated by a dash. For example, 1:3
specifies slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
specifies all of the ports between slot 1, port 3 and slot 2, port 4
−
in numerical
order.
all
−
configure port security for all ports on the switch.
admin_state [enable|disable] – enable or disable port security for the listed
ports.
max_learning_addr <1-64> - use this to limit the number of MAC addresses
dynamically listed in the FDB for the ports.
lock_address_mode[DeleteOnTimout|DeleteOnReset] – delete FDB dynamic
entries for the ports on timeout of the FDB (see Forwarding Database
Commands). Specify DeleteOnReset to delete all FDB entries, including static
entries upon system reset or rebooting.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure the port security: