D-Link TM DES-6500, Command Line Interface Reference Manual, Page: 146 / 267

DES-6500:4#config 802.1x auth_parameter ports 1:1 – 1:12
direction both
Command: config 802.1x auth_parameter ports 1:1 – 1:12
direction both
Success.
DES-6500:4#
config 802.1x auth_protocol
Used to configure the 802.1x authentication protocol on the switch.
Syntax config 802.1x auth_protocol [local|radius_eap]
Description The config 802.1x auth_protocol command enables you to configure the
authentication protocol.
Parameters Local|radius_eap – Specify the type of authentication protocol desired.
Restrictions
Purpose
Only administrator-level users can issue this command.
Example usage:
To configure the authentication protocol on the switch:
DES-6500:4#
config 802.1x auth_protocol local
Command: config 802.1x auth_protocol local
Success.
DES-6500:4#
config 802.1x init
Purpose Used to initialize the 802.1x function on a range of ports or a list of MAC
addresses.
Syntax config 802.1x init [port_based ports [<portlist|all>]
Description
The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
Parameters port_based – This instructs the switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can then
be specified.
<portlist>
−
Specifies a range of ports. The port list is specified by listing
the lowest slot number and the beginning port number on that slot,
separated by a colon. Then the highest slot number, and the highest
port number of the range (also separated by a colon) are specified. The
beginning and end of the port list range are seperated by a dash. For
example, 1:3 specifies slot number 1, port 3. 2:4 specifies slot number