D-Link DES-7200, Cli Reference Manual

Page: 514 / 1180

Chapter 33 BGP4 Configuration Commands DES-7200 CLI Reference Guide
33-40
DES-7210(config-router-af)# neighbor 10.1.1.1 allowas-in
Related
commands
Command Description
router bgp Enable the BGP protocol.
neighbor
remote-as
Configure the BGP peer.
Platform
description
33.1.43 neighbor as-override
Use this command to allow the PE to override the AS number of a site. The no form
restores the setting to the default value.
neighbor { peer-address | peer-group-name } as-override
no neighbor { peer-address | peer-group-name } as-override
Parameter
description
Parameter Description
peer address IP address of the peer
peer-group-name Name of the peer group of up to 32 characters
Default
configuration Disabled.
Command
mode
BGP configuration mode, address-family IPv4 configuration mode,
address-family IPv4 VRF configuration mode.
Usage
guidelines
In general, the BGP will not receive the messages of the same AS
number as its AS. This command can override the AS number, so
that the BGP can receive the messages of the same AS number.
A typical application is in a VPN where two CEs have the same AS
number. Usually the CEs cannot receive the messages from each
other. Executing this command on a PE will override the AS number
of one CE it connects. As a result, the other CE can receive the
peer
‘s route messages.
This command applies only to EBGP peers.
Examples
DES-7210(config)# router bgp 60
DES-7210(config-router)# neighbor 10.1.1.1 remote-as 100