D-Link DES-7200, Cli Reference Manual

Page: 430 / 1180

Chapter 32 OSPFv2 Configuration Commands DES-7200 CLI Reference Guide
32-30
DES-7210(config-if)# no ip ospf message - digest - key 10 md5 hello10
Related
commands
Command Description
area
authentication
Enable authentication in the OSPF area and
define the authentication mode.
ip ospf
authentication
Enable authentication on the interface and define
the authentication mode.
32.1.27 ip ospf mtu-ignore
Use this command to disable the MTU check when an interface receives the database
description message. The no form of this command is used to restore it to the default.
ip ospf mtu-ignore
no ip ospf mtu-ignore
Default
Enabled.
Command
mode
Interface configuration mode.
Usage
guidelines
After receiving the database description message, the device will
check whether the MTU of neighbor interface is the same as its own
MTU. If the received database description message indicates an
MTU greater than the interface
‘s MTU, the neighbor relationship
cannot be established. This can be fixed by disabling the MTU check.
Examples
The configuration example below disables the MTU check function on
the interface serial 1/0.
DES-7210(config)# interface serial 1/0
DES-7210(config-if)# ip ospf mtu-ignore
32.1.28 ip ospf network
Use this command to configure the OSPF network type in the interface configuration mode.
The no form of this command is used to restore it to the default.
ip ospf network { broadcast | non-broadcast | point-to-multipoint [ non-broadcast ] |
point-to-point }
no ip ospf network { broadcast | non-broadcast | point-to-multipoint [ non-broadcast ] |
point-to-point }