Cynosure Cynergy, Technical Manual

Page: 94 / 194

92 of 112 850-1265-000, Rev. 4 Cynosure, Inc.
Replacing the Deionizer (DI) Cartridge
1. Drain the water.
2. Remove the right side panel as detailed on page 54.
3. Remove the old deionizer, located on the frame assembly by removing the tubing at the
fittings, and then opening the clamps. Remove the old cartridge.
4. Insert a new cartridge, and then attach the tubing. If the cartridge does not have fittings,
the fittings must be transferred. Clean the threads of any old Teflon tape first. Then
place approximately 1.5 turns of new Teflon tape on the male threads, turning by hand
until tight.
Calibrating the Dye Concentration Monitor
1. Turn on the laser.
2. Enter Testall Mode as detailed on page 19.
3. Attach the red lead from the DVM to TP20. Attach the black lead from the DVM to
TP3 (ground).
4. From Testall mode, press lowercase ‘l’ to increase or uppercase ‘L’ to decrease the
voltage until the DVM reads from 1.99V to 2.010V.
Calibrating the Dye Temperature
1. Turn on the laser.
2. Enter Testall Mode as detailed on page 19.
3. Place thermocouple probe into the dye reservoir through the hole provided for the
charcoal filter.
4. Press lowercase ‘y’ and then enter the temperature reading on the DVM.