Cynosure Cynergy, Technical Manual

Page: 124 / 194

Cynergy Final Test and Calibration Procedure Doc #991-4906-000
Page 5 of 28
Rev 5
3 Overview
3.1 This document describes how to calibrate and test the Cynergy laser System.
4 Stress Test
4.1
Verify that the water tubing is properly connected and that all fittings are tight.
4.2
Inspect the system for loose wires and hardware.
4.3
Run the laser over the path of the vibration test fixture three times.
5 Test Resistance of Ground Connection
5.1
Set the Fluke Model 87 digital multimeter to read 4½-digit display by depressing the
yellow button and turning the select knob to
Ω
(Ohms) while holding the yellow button
for three seconds.
5.2
Connect the red lead to the ground pin of the laser AC line cord.
5.3
Connect the black lead to the chassis ground.
5.4
Measure the ground resistance and verify that it is
≤
100m
Ω
(
≤
0.100 Ω ).
6 Set AC Voltage Selection
6.1
Set digital multimeter to measure AC Voltage (‘AC Volts’ or ‘V RMS’ scale).
6.2
Measure the line voltage at the wall outlet that the laser’s AC line will be plugged into.
6.3
Insert the leads of the multimeter to the ‘hot’ and ‘neutral’ terminals of the wall outlet.
6.4
Locate the AC voltage selection PCB #710-0124-000, accessible from the back of the
laser. There are four connectors on the board for the voltage selection.
6.5
Connect the 6-pin AC Select plug to the correct connector based on the line voltage
measured from the wall outlet.
Measured Line Voltage Connector
110V - 181V DO NOT USE 120V Connector (DEMO ONLY)
195V – 200V plug into 200V Connector
201V - 220V plug into 220V Connector
221V - 245V plug into 240V Connector
6.5
Set the HVPS charge rate switch to the (4000 J/sec) position. The switch is located on
the top of the HVPS.