Cynosure Cynergy, Technical Manual

Page: 129 / 194

Cynergy Final Test and Calibration Procedure Doc #991-4906-000
Page 10 of 28
Rev 5
21 Verify YAG F.O.M
21.1
Remove beam combiner block.
21.2
Position the Ophir detector head 14 to 16 inches from the YAG pump chamber.
21.3
Power up laser
21.4
Type < cv> from the “C:\” prompt (CV mode).
21.5
Laser Setup:
Set laser WL = YAG (1064)
Vol
Pul
Rep
tage = 750v
se Width = 5msec
Rate = 1Hz
21.6
Fire the laser 10 shots and read the power on the meter.
21.7
Increase the YAG laser voltage to 850 volts.
21.8
Fire the laser 6 shots and read the power on the meter.
21.9
The resonator should measure ≥ 55 watts @ ≤ 850 volts . NOTE: (Do not EXCEED 85
Watts).
21.10
Record the YAG resonator power @ 850 volts on Data Sheet #991-4909-000.
22 Calibrate Dye Absorbance
22.1
Install the Dye Test filter.
22.2
Install the Dye Test inject bottle.
22.3
Squeeze the Dye bottle until the Dye input tubing line is filled with Dye.
22.4
Power up laser
22.5
Type < cv> from the “C:\” prompt (CV mode).
22.6
Select laser wavelength to PDL (PDL Laser).
22.7
Let laser run until DYE temp is ~ 39 degrees C. ( Approx. 15 Min )
22.8
Remove the Dye tank charcoal filter located on top of tank.
22.9
Using the syringe from the colorimeter kit (
#706-0148-000), t
ake a sample of dye out of
the Dye tank.
22.10
Place the Dye sample into the glass tube and measure the optical density using the
colorimeter
#706-0148-000
.
22.11
With a properly charged test filter, the sample should measure between 0.75 to 1.1
22.12
Press lower case “ z ” and enter the value measured in step 22.10.
22.13
Record the DYE Absorbance value on Data Sheet #991-4909-000.