Cynosure Cynergy, Technical Manual

Page: 142 / 194

Cynergy Final Test and Calibration Procedure Doc #991-4906-000
Page 23 of 28
Rev 5
39 Remote Interlock Verification
39.1
Power up laser
39.2
Type < cy > from the “C:\” prompt (operating mode).
39.3
Wait for laser to come up to the main menu page.
39.4
Unplug the connector from the jack on the back of the upper chassis.
39.5
A warning message should appear on the display.
39.6
Replace the jumper plug.
39.7
The warning message should clear from the display.
40 Test Emergency Stop
40.1
Power up laser
40.2
Type < cy > from the “C:\” prompt (operating mode).
40.3
Wait for laser to come up to the main menu page.
40.4
Press down on the EMERGENCY STOP switch.
40.5
Verify that the laser system fans and pump shut off.
40.6
Turn the EMERGENCY STOP switch to the right
40.7
Verify the fans and pump re-start.
41 Re-Set DYE Lamp Counter
41.1
Power on laser and go to the C:\.
41.2
Type < TN> from the “C:\” prompt (TESTALL mode).
41.3
Prompt the MENU screen by pressing < Space > on the keyboard.
41.4
Press lower case letter ‘ w’ on the computer keyboard ( set wavelength to 0 DYE).
41.5
Press lower case letter ‘ q’ on the computer keyboard.
41.6
Press upper case letter ‘ Z’ on the computer keyboard (Zero DYE flashlamp counter).
41.7
Press upper case letter ‘ Q’ on the computer keyboard.
41.8
Press upper case letter ‘ Z’ on the computer keyboard. (Zero DYE counter)
42 Re-Set YAG Lamp/Rod Counter
42.1
Power on laser and go to the C:\.
42.2
Type < TN> from the “C:\” prompt (TESTALL mode).
42.3
Press lower case letter ‘ w’ on the computer keyboard ( Set wavelength to 1 YAG).
42.4
Press lower case letter ‘ q’ on the computer keyboard.
42.5
Press upper case letter ‘ Z’ on the computer keyboard (Zero YAG flashlamp counter).
42.6
Press upper case letter ‘ Q’ on the computer keyboard.
42.7
Press upper case letter ‘ Z’ on the computer keyboard. (Zeros YAG Rod counter)