CynkoMet N-233 Series, Instructions For Use And Operation

Page: 82 / 149

Cynko Met
N-233
Page 82
7. Transport
The spreader is prepared for sale in a complete state and does not
require packing. Only the instruction manual of machine handling and
the connecting cable of the electrical system undergo packaging.
The delivery of the spreader to the user is done by independent
transport after connecting with the tractor or automobile (in this case,
the spreader because of the height can be mounted on the platform of
the transport mean on the hubs - with unscrewed and taken off wheels
or on wheels secured with chocks, but with disassembled and folded
upper extensions.
Loading and unloading of a spreader from a car should be carried
out using the loading ramp with an agricultural tractor or using a crane,
lever. During operation, observe the general safety rules with handling
operations. Persons operating the reloading equipment must have the
required permissions to use these devices.
When loading / unloading using the tractor, the spreader must be
properly connected with the tractor according to the requirements
contained in this manual. The spreader braking system must be running
and tested before running off or driving on the ramp.
When loading / unloading using a crane or a lever, the spreader is
to be lifted with the help of approved fasteners designed to carry the
load with sufficient capacity. The belts must be in good condition, they
cannot show any signs of damage.
The belts should be placed under the lower frame of the spreader
in such places that when lifting the machine the belts do not have the
possibility of moving, and the spreader when moving is not tilting. If
there is a possibility of damage or frayed belts against components of
the machine, put washers in sensitive areas.
In order to avoid compression of the walls to the inside the
spreader, when loading with the use of a crane, use a special traverse,
where the places of hooking the belts will be spaced wider than the total
width of the machine.
The spreader should be attached firmly to the platform of the
transport mean with belts, chains, lashing or other fastening means
equipped with a tightening mechanism. Fastening elements are to be
fastened to fixed structural elements of the spreader (longitudinal
beams, cross-bars, etc.). Transport handles are welded to the