CynkoMet N-233 Series, Instructions For Use And Operation

Page: 67 / 149

Cynko Met
N-233
Page 67

replace the hose.
The steps are analogous when testing the tightness of the
hydraulic brake system. If leaks occur after pressing down on the brake
for 30 seconds, proceed as above.
Hydraulic hoses should be replaced at least every four to six years
from their date of manufacture, unless previously found to be damaged
and replaced.
In the case of noting oiling on the body of the hydraulic cylinder,
check the nature of the leak. When fully taking out the cylinder actuator,
check all sealing places. Minor leaks with symptoms of "sweating" are
acceptable, but if you see a leak of a "drip" type, you must stop the
spreader’s operation and repair the failure.
CAUTION!
CAUTION!
The state of the hydraulic system should be controlled up
to date during its use. It is prohibited to use a machine
with a damage hydraulic system of the rear wall or brakes.
6.5 Maintenance of the drive axle.
Maintenance of the drive axle is based on continuous inspection of
the condition of brakes and checking for cracks. It should not be
permitted for a thick layer of dried mud to accumulate on the system.
CAUTION!
CAUTION!
In the case of noticing a cracked part, e.g. a bow screw,
the machine should be out of operation until the fault has
been rectified.
6.6 Mounting the adapter's drum guard
The guard of the adapter's drums is required for driving with the
spreader on public roads. The spreader is delivered with the lever
serving to open the guard dismounted. Figure 19 presents the mounting
procedure.