CynkoMet N-233 Series, Instructions For Use And Operation

Page: 49 / 149

Cynko Met
N-233
Page 49
In order to disconnect the spreader from the tractor, perform the
following steps:
 switch off the engine and remove the keys from the ignition

pull the parking brake in the tractor and spreader

if the spreader with the cargo is located on a steep slope, it should be
protected additionally against rolling by planting chocks under the
machine's wheel.

disconnect the hydraulic, electrical and brake system cables of the
trailer from the spreader.

disconnect the drawbar from the tractor transport hitch and drive the
tractor away.
CAUTION!
CAUTION!
When disconnecting the spreader from the tractor, keep
particular caution.
Provide yourself a good visibility. Before disconnecting the
hoses and rods, the cabin of the tractor must be closed to
prevent it from unauthorized access. The tractor engine is
to be turned off and remove the key from the ignition.
CAUTION!
CAUTION!
Pay attention to the compatibility of oils in the tractor
hydraulic system and the hydraulic system of the spreader.
4.3.6 Loading the crate.
CAUTION!
CAUTION!
Loading of the cargo bed can take place only when the
spreader is connected to the tractor, set on level ground, and
when the parking brake is engaged on the tractor and spreader.
You should aim for even load distribution in the loading crate.
When loading or unloading the spreader, it is recommended to use a
crane, loader or a conveyor according to general safety rules. Before loading,
check that all the moving parts are closed (locks, guards, etc.)
Lightweight, bulk materials may be loaded even above the cargo bed’s
extensions, however, only up to 5cm above the edge of the side walls, paying
special attention to the spreader's stability.