CynkoMet N-233 Series, Instructions For Use And Operation

Page: 80 / 149

Cynko Met
N-233
Page 80
Fault Reason Way of removal
Problems with
moving
Disconnected hoses of the
brake system
Connect the brake
hoses
Parking brake engaged
Release the parking
brake
Damaged connection
cables of the pneumatic
system
Replace
Connections leakage
Tighten, replace
washers, seal sets,
replace the hoses.
Damaged control valve or
brake force regulator
Check the valve, repair
or replace it
Noise in the hub of
the driving axle
Excessive clearance on the
bearings
Check clearance and
adjust if necessary
defective bearings replace bearings
damaged items Replace
Low efficiency of
the braking system
Excessive heating
of the driving axle
hub
Pressure too low in the
system
Check the pressure
gauge on the tractor,
wait till the compressor
fills the tank to the
required pressure.
Improperly adjusted
essential or parking brake
Adjust the position of the
spreader arms
Worn out brake linings
Replace the brake
shoes
Installation leakage
Check the tightness of
the installation
Damaged air compressor in
the tractor
Repair or replace.
Damaged brake valve in the
tractor
Repair or replace
Uneven feed
Damaged flow regulator Replace
Damage of the conveyor
elements
Remove the damaged
element, clean the
socket wheel
Uneven spreading
of the material on
the box
Spreading element (the
knife, scattering strip)
absent or damaged
Replacement of the
damaged item with a
new one
Clogging adapter
Mismatched conveyor feed
to the spread material
Adjust the feed conveyor
in accordance with the
spread material
Mismatched conveyor feed
to the spreader driving
speed
Adjust the feed conveyor
according to the vehicle
speed
Improper operation
of the hydraulic
system
Improper hydraulic oil
viscosity
Check the quality of oil,
make sure that the oil in
both machines is of the
same type. If necessary,
replace the oil in the
tractor and / or spreader
Insufficient efficiency of the Check the hydraulic