CynkoMet N-233 Series, Instructions For Use And Operation

Page: 40 / 149

Cynko Met
N-233
Page 40
4.3.1.2 Preparing the spreader for the first connection.
Preparation

Check all lubrication points of the spreader, if necessary, lubricate the
machine (section 6.10).

Check for proper tightening of nuts fixing the driving wheels (Tab. 7,
section 6).

Drain water from the air tank in the pneumatic brake system (section
6.3).

Make sure that the pneumatic, hydraulic and electrical connections in
the agricultural tractor are compliant with the machine’s connection
points, otherwise do not connect the spreader.

Adjust the height of the shaft location in the spreader or the position of
the upper transport hitch on the tractor through a regulated bracket.
Trial drive / start
If all the above steps have been performed and the technical condition
of the spreader does not raise any objections, connect the machine to
the tractor in compliance with the following sequence.

secure the spreader against uncontrolled rolling of through the
use of a parking brake and placing wheel chocks under the wheel.

set the spreader shaft at the height of the hitch in the tractor using
the adjustable support.

perform the reversing maneuver and couple the drawbar to the
tractor's hitch.

switch off the tractor’s engine (turn the key to the desired position
and remove the key from the ignition), set the parking brake on
the tractor.

check the correctness of the connection of the drawbar to the
hitch in accordance with the instruction manual of the tractor.

connect the power take-off and fasten guards into place.

Connect all installations according to the instructions of the tractor
and spreader.

raise the adjustable bracket and set the wheel of the bracket in
the “up” position (so that it does not catch on the ground during
driving).