Cybex Owner’s Manual
45
Exit Set Up Mode by
tapping the
Toolbox
ico
n
, then tap the
Home
icon
. The screen will
refresh.
Setup Complete
Testing Operation
Use the following instructions to test the full speed and incline range of the treadmill and to check the
belt for proper operation.
WARNING: Falling hazard.
When starting unit
•
Stand on two top steps.
•
Do not stand on belt.
1.
Plug the power cord into a power outlet from a grounded, dedicated circuit as described under
Electrical Requirements in this chapter without anyone on the treadmill.
Ensure the power cord is not being pinched under the front of the treadmill.
2.
Toggle the on/off (I/O) power switch under the front end of the treadmill to the on position (I).
The control panel will light up and be in the opening screen.
3.
Press the
Quick Start
key. The treadmill begins a countdown “3...2...1” and sounds a tone
for each count. After it reaches one (1), the treadmill gives a longer tone and then begins
accelerating the belt to reach 0.5 mph (0.8 kph). The lower left display will show the incline and
the lower right display will show the actual speed.
4.
Press and hold down the
Speed
+
key until the treadmill reaches a speed of approximately 4
mph (6.4 kph), as indicated on the display.
Observe the belt to see that it is running properly; it should stay centered in the middle of the deck. If
you have problems with the running belt operation, see Running Belt Adjustments in the Maintenance
chapter.
5.
Run the treadmill through its full speed range. First press the
Speed +
key until the treadmill
reaches its highest speed. Then press the
Speed -
key until the treadmill is back to 0.5 mph
(0.8 kph).
Pressing the Incline ▲▼ or
Speed
+ -
keys will show the set incline or speed on the displays.
When the treadmill reaches the set incline and speed, the displays will remain steadily illuminated to
indicate that the desired settings have been reached.
6.
Run the treadmill through its full % grade range. Press the
Incline
▲ key until the treadmill
reaches its highest grade (20%). Then press the
Incline
▼ key until the treadmill reaches 0%
grade.
7.
Press the
Stop
key once to stop the running belt and enter
Review Mode
. Press the
Stop
key
again to exit Review Mode and return the display to the opening screen.
