Chapter 2. Installing Your ATS
2.5
Checking Communications Between the Link
and the Wafer
To complete the installation, verify that the teaching wafer and link can communicate:
1. The teaching wafer operates from an internal rechargeable battery. Before using the
teaching wafer for the first time, charge it for two hours. For information on checking the
charge on the battery and the procedure for recharging, see
2. Remove the teaching wafer from the charging clean box and press the
ON OFF
button
to turn on the teaching wafer.
The
On
light on the teaching wafer turns on.
3. Verify that the
Pair Status
lights on both the teaching wafer and link module are on. If
either light is not on, your teaching wafer and link might not be paired with each other. To
reset the pairing, see
“Changing the Pairing Between the Teaching Wafer and Link,” on
.
4. Immediately after turning on the teaching wafer, the
Connection Status
lights on the
teaching wafer and link will blink slowly. After a few seconds the teaching wafer and link
will connect and both lights will be on and no longer blinking. If the lights continue to
blink, see
“Monitoring the Wireless Connection to the Teaching Wafer,” on page 3.18
5. After starting the TeachView application (see
“Running the TeachView Application,” on
), you can verify the connection to the teaching wafer by comparing the serial
number printed on the teaching wafer to the serial number shown in the About Your ATS
Wafer dialog, which is available in the TeachView application by choosing the
Help >
About your ATS Wafer
menu item.
That completes the installation of your ATS.
