28
EXPERT 64+, rev.12
EXPERT 64+
1. Select
»
10. Select Program
Select Program
Running program
Program 1
Clean Mode Status
On
Detect Lo Temperature?
No
2. Set the following parameters:
Clean Mode Status —
Select
“Yes”
to activate
the clean mode. Note that all the controller
functions are stopped when the clean mode
is active (except for the heating outputs).
Detect Lo Temperature —
Select
“Yes”
for
an alarm to be activated when the house
temperature decreases below the Empty
Zone Alarm Limit while the controller is in
clean mode.
4.10. Controller’s Version
The version menu gives the version number
of the program used by the controller. This
piece of information is useful to get techni-
cal support.
1. Select
»
12. Setup
»
10. Version
EXPERT 64+
SETTINGS V X.X
PROGRAM V X.Xx
4.11. Test Mode
The test mode is used to simulate changes
in the ambient temperature and verify the
controller’s performance. When the test is
enabled, all outputs of the controller operate
according to the simulated temperature. The
test automatically ends after 15 minutes of in-
activity or if the user deactivates it manually.
1. Select
»
12. Setup
»
11. Test Mode
Test Mode
Test Mode Status
Off
Temperature
80.0 °F
Static Pressure
.00 ”WC
Running Program
Program 1
2. Set the following parameters:
Test Mode Status —
Select
“Yes”
to activate
the test mode.
Temperature —
Set the simulated house tem-
perature. *
This parameter can only be changed if
the test mode status is enabled above.
Static Pressure / Running Program —
The
static pressure level and current program in
use are displayed as readings for information
purpose only. They cannot be modified.
Summary of Contents for EXPERT 64 Plus
Page 1: ...EXPERT 64 Temperature Controller User s manual...
Page 62: ......
Page 76: ...M 890 00077 rev 12 REV 07...
