CUBICON Single Plus
User Manual
23
* Sensor may not operate properly due to TPU ductility ,in the time of TPU printing. Make sure to
go to Setting > Function > Filament check OFF in prior to using ductile filament.
* Filament pieces, which come out by automatic unloading in the time of the filament passes through
the detection sensor, might be different depending on the printer model.
The amount of filament
pieces might decrease as far as area gets wider and it makes pull out of filament pieces
impossible.
Make sure to check remaining filament amount in prior to printing, as reprinting might
be needed.
8.
Test model printing
This section explains from the installation to printing by using USB memory.
Refer to Cubicreator Software
manual for method of printing through PC and USB cable connection.
8-1. First printing
① ‘7-1 Start loading after reading ‘Loading’ section.
② Loading completion means printing preparation
completion.
8-2. Sample file of USB memory printing
Direct printing
① There is a sample file for printing in provided USB
memory.
② Select a file icon by pressing a print icon. Select
installed filament suitable clip.hfb file and print it out.
