CUBICON Single Plus
User Manual
20
Make sure to check if the filament is extruding through a nozzle.
* Make sure to keep a nozzle part away from your body as nozzle gets hot once nozzle temperature of
the extruder gets high and melted filemant is also hot.
* The filament may get caught to a nozzle bar entrance in the process of the filemant goes into nozzle
bar of detachable extruder part. (you may hear crack sound) In that case, press the filament press
handle and pull filament up. Then cut the end part of filament with scisorrs and try loading again
putting the filament into insert hole.
* In the case of manual working by using the filament press handle, make sure not to pull the filament
up with extreme power as it may cause inside sensor or nozzle bar damage.
